CHNSpec Technology (Zhejiang)Co.,Ltd chnspec@colorspec.cn 86--13732210605
Hello everyone, in order to provide convenience for everyone to use, this issue we focus on the use of the new CS-700 operation.
Step 1: Turn on the power and turn on the system
Step 2: Parameter setting
After boot, you can set parameters in the user wizard, you can also enter the Settings inside the operation. Measurement Settings include measurement parameters, light source selection, exhibition criteria, tolerance Settings and average Settings.
Step 3: Calibrate
Keep the compensating port cover covered in ASTM mode and calibrate as prompted.
Step 4: Standard sample, sample measurement (ASTM standard)
Enter the measurement page, standard sample measurement: fit the standard sample to the test port, press the measurement key, and save the measured data; Sample measurement: Replace the test port with the sample, press the measurement key, compare the difference between the standard sample and the sample, check whether it is qualified, and finally save the data.
Step 5: Data review
You can view the test data in Data View
The compensation port cover is kept open under ISO standards, and all measurements involving transmittance parameters need to be measured at the compensation port once