Hello, everyone, in order to provide convenience for everyone's use, this issue we focus on the use of the new TH-110 operation ~
Step 1: Turn on the power and turn on the system
Step 2: Parameter setting
Adjust parameters as needed. Measurement Settings include measurement parameters, light source selection, exhibition criteria, tolerance Settings and average Settings.
Step 3: Calibrate
Calibrate the fog meter before measurement
Step 4: standard sample, sample measurement
Enter the measurement page, standard sample measurement: fit the standard sample to the test port, press the measurement key, and save the measured data; Sample measurement: Replace the test port with the sample, press the measurement key, compare the difference between the standard sample and the sample, check whether it is qualified, and finally save the data.
Step 5: Data review
You can view the test data in Data View
Linked computer operation
The instrument is connected to the computer through the USB cable, and the Haze QC software is installed on the computer. Opening the software can realize the operation of the instrument calibration, measurement and printing report by the computer software